MicroLimpet

Heaters

SMALL FOOTPRINT LIMPET HEATER
The MicroLimpetTM has a smaller heating footprint than the Alpha & Beta series and can either work independently with a pre-set temperature control or act as a "secondary" unit driven from a control AlphaLimpet.

MicroLimpetTM heaters are produced in a variety of power options. Their smaller size allows easier fitting into smaller spaces or onto OmegaLimpets (flange heaters).



Applications

The MicroLimpet is used in conjunction with an adapter block to heat smaller process equipment. Examples are below.

Flange Heating

SMALL PUMPS AND VALVES

Two MicroLimpets with Omega adaptor blocks heating a centrifugal pump that was constantly freezing up. Since installation, the system has never frozen up again


Main Features
Compact, economic, cost saving, clean heating

Robust IP67 aluminium case.

Maximum operating temperature 80°C.

110 / 230 Volts; up to 120W power output.

Conduit entry or IP-rated plug & play sockets.

Technical Details
Dimensions: 156mm long (excluding connectors) x 40mm wide x 50mm high. Adaptor blocks can be provided where necessary.

Voltage: 110Vac or 230Vac.

Power rating: up to 130W (110Vac) or 120W (230Vac).

Temperature range: When controlled by an AlphaLimpet 0°C to 80°C. When working independently, 0°C to 250°C.

Minimum operating temperature: -30°C.

Temperature control: When controlled by an AlphaLimpet ±1°C. When working independently, ±5°C.

Colour: Red.