Excalibar Chocolate Enrober

Heater

The Limpet 'Excalibar' is used for heating various options in chocolate enrobing machines
Chocolate enrobing machines can suffer from the buildup of chocolate in parts of the machine, notably around the mesh conveyor rollers both inside and at the ends, inside end panels or on scraper bars.

To address this, Limpet Heating have developed their unique 316 stainless steel 'Excalibar' heating bar, which can be retrofitted to existing machines or installed in new ones, ensuring that the chocolate stays liquid, thereby reducing maintenance downtime.

Limpet Excalibar Heaters can be custom-designed to fit any size of machine and can be supplied in either 110Vac or 230Vac versions. They can deliver up to 800W, depending upon the width of the machine.

The heater bar is controlled by a MegaLimpet located in a suitable position in the machine housing. This provides accurate temperature control using our patented Limpet control technology.

Microprocessor Accuracy

Featuring a microprocessor built within the heater block

Programmable

Allows users to override the internal set-point, monitor the spare temperature sensor port and control the unit externally

Different Modes

A Limpet can also be used in “Primary” or “Secondary” mode

Monitoring

The user can monitor the heater’s status using a simple linked-together healthy signal


Example of a chocolate enrober heating application: Biscuit inverter bar

The enrobing machine had consistent problems with biscuits being thrown out of alignment when they were inverted after enrobing. This resulted in a very high level of waste - typically 20 biscuits per minute.

Limpet designed and built a heated bar that replaced the existing heating system and resulted in biscuits turning over correctly and hence eliminating the waste.